By admin /

This specification does not concern legal or safety standards. 26/11/, 1/3. 1 Charging characteristic: IUa (according to DIN ). Regime. Switching. transformer, input PF , low input harmonics (DIN (UI). Find the most up-to-date version of DIN at Engineering

Author: Tarisar Gajind
Country: Martinique
Language: English (Spanish)
Genre: Music
Published (Last): 28 October 2015
Pages: 446
PDF File Size: 20.97 Mb
ePub File Size: 8.15 Mb
ISBN: 709-6-13031-369-1
Downloads: 83607
Price: Free* [*Free Regsitration Required]
Uploader: Shakora

Stage 2 is called the U o -phaseconstant-voltage boost stageabsorption stageor topping charge.

This phase occurs when an IUoU charger is 41737 to a deeply discharged battery. I-phase constant electric currentUo-phase constant over- voltageand U-phase constant voltage. The voltage U o may be the same as U max in the previous stage, or it may be taken slightly higher.

If a battery is connected to a significant load during charging, the end of the Uo-phase may never be reached and the battery will gas and be damaged, depending on the charge current relative to the battery capacity.

The U o -phase is concluded when the charge current goes below a threshold I minafter which the U-phase is entered. IUoU is a DIN -designation [1] DIN for a lead-acid battery charging procedure that is also known as 3-stage charging3-phase chargingor 3-step charging. The charging current is a compromise between charging time favoring high currentsthe prevention of damage due to overheating or gassing favoring low currentsand cost of the charger favoring low currents.

  INTEGO VX-85 PDF

A bad battery will have short I-phase and Uo-phase, but there is a risk of gassingfurther damaging the battery. Stage 1 is called the I-phaseconstant-current stageor bulk charge stage. The three phases are: From Wikipedia, the free encyclopedia. The current in the I-phase stage 1 should be chosen depending on the capacity of the battery. During this phase, the charge current decreases gradually to a small residual value that compensates for any self-discharge of the battery.

In this stage, the battery is continued being charged at a constant over voltage U obut the charge current is decreasing. The charger provides a constant current, typically the maximum current that the charger is capable of producing.

Views Read Edit View history. This page was last edited on 24 Mayat Stage 3 is called the U-phase or float charge statethe voltage is reduced to a value that is safe to be applied for 4177 periods weeks 4177 significantly reducing the lifetime of the battery.

IUoU battery charging

The voltage in the U o -phase is too high to be applied indefinitely hence, overvoltagebut it allows charging the battery fully in a relatively short time. The charger limits the maximum voltage to U maxa constant or temperature-dependent maximum, typically rin 2. The decrease is imposed by the battery. It consists of three phases or stagesto be executed by a battery charger.

  LA CAMBIALE DI MATRIMONIO LIBRETTO PDF

IUoU battery charging – Wikipedia

By using this site, you agree to the Terms of Use and Privacy Policy. The battery capacity C is expressed in Ah units, typically the C 20 value based on a hour discharge time.

In practice, it depends on the capability of the charger. The purpose is to fully charge the battery in a relatively short time without reducing its life span and to indefinitely keep the battery charged as long as the charger is connected. The voltages in the U and U o phases stages 2 and 3 depend on the type of battery and the temperature.

Batteries have varying numbers of cells typically six for an automotive battery and may be flooded-cell, absorbed-glass-matt AGMor gel-electrolyte types. As a result of the current, the battery absorbs 41737 charge and its voltage rises.

Retrieved from ” https: For the alternating-current system, see Three-phase electric power.