By admin /

MCT2 and MCT2E are also available in white package by . MCT2E. MCT2E-M. MCT V. (IC = 16 mA, IF = 32 mA, TA = °C). Details, datasheet, quote on part number: MCT2E Collector-emitter saturation voltage Input-to-output internal resistance TEST CONDITIONS = 10 µA, IC =1. MCT2E ON Semiconductor / Fairchild Transistor Output Optocouplers DIP-6 PHOTO TRANS datasheet, inventory & pricing.

Author: Samutilar Sagar
Country: Guyana
Language: English (Spanish)
Genre: Love
Published (Last): 5 January 2017
Pages: 339
PDF File Size: 1.49 Mb
ePub File Size: 3.56 Mb
ISBN: 165-1-72754-511-5
Downloads: 20867
Price: Free* [*Free Regsitration Required]
Uploader: Zulkiran

This is the logic output pin 6 Base B Base pin of the Transistor. The ground line of the IR LED pin 2 and the ground line of the transistor pin 4 will not be connected together. Base pin of the Transistor. Submitted by admin on 7 March The below waveform shows the time taken for the output to transit from one state to another. Connected to isolated ground.

This mct2d where the isolation occurs. Datashete the IR led is powered the light from it falls on the transistor and it conducts.

IC MCT2E Optocouplers

The digital signal given to the IR LED will be reflected on the transistor but there will be no hard electrical connection between the two. The complete working can also be understood form the GIF file above.

  BORANG R01 PDF

This IC is used to provide electrical isolation between two circuits, one part of the circuit is connected to the IR LED and the other to Photo-transistor. TL — Datashset Reference Voltage.

Out of which the Phototransistor mode is mostly used, so let us look at that mode first. This way the logic input will be reflected at the logic output and still provides and isolation between the dagasheet. Then Pull high the collector pin of the transistor using a resistor here I have used 1K and connect the collector pin to the output of your desired logic circuit.

This comes in very handy when you are trying to isolate a noisy signal from your digital electronics, so if you are looking for an IC to provide optical isolation in your circuit design then this IC might be the right choice for you. It is normally not used for transistor mode, but will be datasheey in diode mode. This will short the collector and emitter and hence the Logic Output voltage will become zero. More details can be found at the MCT2E datasheet which is available for download at the end of this page.

  HP3456A MANUAL PDF

MCT2E Datasheet(PDF) – TI store

Another important parameter to consider while using an Optocoupler, is the rise time tr and fall time tf. The output will not get high as soon as the input logic is made low uc vice versa.

The Emitter pin 4 is grounded. There pull-up resistor 1K acts as a load resistor. In the Photo-transistor mode we will not be using the base pin pin 6 of the transistor; we just have to connect the anode pin of the IR LED pin 1 to the logic input which has to be isolated and the cathode pin 2 of the IR led to the ground.

But when the Logic input is made high, this high voltage should be a minimum of 1.